mommygasra.blogg.se

1. YOUTUBE MAC POWERBOOK PRO REPLACE HARD DRIVE HOW TO
2. YOUTUBE MAC POWERBOOK PRO REPLACE HARD DRIVE SOFTWARE

To wake the computer, press any key on the keyboard (except Caps Lock). Other ways of putting your computer to sleep m You can choose the Sleep command from the Special menu to put your computer to sleep.Īutomatic sleep If you don’t use the computer for several minutes, it goes to sleep automatically. To put the computer to sleep, do this: 1 Press and hold the Power key for about two seconds. Follow these steps: 1 If the computer is in sleep, press the Power key (or any key on the keyboar. See â.ġ0 Chapter 1 Turning the computer off with the Shut Down command You can also turn your computer off by using the Shut Down command in the Special menu. You may need to reinstall system software.

YOUTUBE MAC POWERBOOK PRO REPLACE HARD DRIVE SOFTWARE

This icon usually means that the computer can’t find system software on the hard disk or any disks attached to the computer. M You see a picture of a disk with a blinking question mark on the screen. If the computer does not start up, go to th.

YOUTUBE MAC POWERBOOK PRO REPLACE HARD DRIVE HOW TO

You should hear a ton.Īfter the computer has started up for the second time, go to the section “What’s Next?” for more instructions, or finish reading this chapter to learn how to turn the computer off and put it to sleep. 1 Press the Power key at the upper-right corner of the keyboard to turn the computer on. Turning the computer on To turn on the computer for the first time and prepare it to record any settings you establish, follow these steps. 2 Plug the power adapter plug into the power adapter port (marked with the icon ¯ ) on the back panel of the computer. ġ Plug one end of the power cord into the power adapter and the other end into a three- hole grounded outlet or power strip. Avoid touching the battery’s metal contacts as you peel off the wrapper. 5 Carefully remove the wrapper from the battery. 4 Slide the battery out of its compartment. Removing the battery’s.ģ Press the battery release button on the battery. It is a good idea to lower the elevation feet whenever you are using your computer on a flat surface.

The back of the keyboard is slightly elevated when the feet are in use. Slide the latch to the left.ģ Adjust the elevation feet to raise the computer. You can adjust the angle of the display at any time by tilting it toward or away from you. 2 Position the display at a comfortable viewing angle. Opening the display 1 Slide the latch to the left and lift up the display. When setting up your computer, place your comput.īattery Infrared window Expansion card label Trackpad Stereo speakers Trackpad button Elevation feet Elevation foot release button g SCSI port (HDI-30) - Sound output port ¯ Power adapter port V Apple Desktop Bus (ADB) port I Reset button. To set up your computer for the first time, you need the power adapter and the power cord that came with it. The illustration on the next page provides an overview of your Macintosh PowerBook computer.